Chain Saw
InstructionManual
MODELS : CS-330T
CS-360T
WARNING
DANGER
Readrulesforsafeoperationandinstructionscarefully.ECHOprovidesanInstruction
ManualandaSafety Manual.Bothmustbereadandunderstoodforproperandsafe
operation.
X750007744
06/06
X7503242004
7. Keep all parts of your body away from the saw
chain when the engine is running.
14.Keep the handles dry, clean, and free of oil or
fuel mixture.
8. Before you start the engine, make sure that
the saw chain is not contacting anything.
15.Operate the chain saw only in well-ventilated
areas.
9. Carry the chain saw with the engine stopped,
the guide bar and saw chain to the rear, and
the muffler away from your body.
16.Do not operate a chain saw in a tree unless
you have been specifically trained to do so.
17. All chain saw service, other than the items listed
in the Instruction Manual maintenance instruc-
tions, should be performed by competent chain
saw service personnel. (For example, if im-
proper tools are used to remove the flywheel
or if an improper tool is used to hold the fly-
wheel in order to remove the clutch, structural
damage to the flywheel could occur and could
subsequently cause the flywheel to burst.)
10.Do not operate a chain saw that is damaged,
improperly adjusted, or not completely and
securely assembled. Be sure that the saw
chain stops moving when the throttle control
trigger is released.
11. Shut off the engine before setting the chain saw
down.
12.Use extreme caution when cutting small size
brush and saplings because slender material
may catch the saw chain and be whipped to-
ward you or pull you off balance.
18.When transporting your chain saw, use the
appropriate guide bar scabbard.
19.Spark arrestor mufflers approved to SAE Stan-
dard J335b are Standard on ECHO Chain
saws to reduce the possibility of forest fires.
Do not operate the chain saw with a loose or
defective muffler. Do not remove the spark ar-
restor screen.
13.When cutting a limb that is under tension, be
alert for spring back so that you will not be
struck when the tension in the wood fibers is
released.
WARNING
DANGER
• Duringoperation,themufflerorcatalyticmufflerandsurroundingcoverbecomehot.
• Neversuspendthesawonalanyardwiththeenginerunning.
• Always use the saw from the right-hand side of your body – NEVER from the left side.
• Always wear proper safety clothing to protect your lower body from sharp saw chain and hot
muffler.
• Always keep exhaust area clear of flammable debris during transportation or when storing,
otherwiseseriouspropertydamageorpersonalinjurymayresult.
WARNING
DANGER
Using improper replacement components or removing safety devices may result in serious or fatal injury.
3
CONTENTS
Page
Rules for Safe Operation .................................................................................................. 2
Technical Data ................................................................................................................. 5
Emission Data ................................................................................................................. 6
Description ...................................................................................................................... 6
Nomenclature of Parts...................................................................................................... 7
Preparation for Use.......................................................................................................... 8
Fuel and Lubricant.......................................................................................................... 10
Operation....................................................................................................................... 11
Starting Cold Engine ...................................................................................................... 11
Starting Warm Engine .................................................................................................... 12
Stopping ........................................................................................................................ 12
Cutting Instructions ......................................................................................................... 13
Maintenance and Care ................................................................................................... 16
Chain and Guide Bar Combinations ............................................................................... 19
Setting the Saw Chain.................................................................................................... 20
Troubleshooting.............................................................................................................. 21
Storage .......................................................................................................................... 24
Correct Use of Chain Brake ........................................................................................... 24
Servicing Information...................................................................................................... 28
INTERNATIONAL SYMBOLS
Symbolform/shape Symboldescription/application Symbolform/shape Symboldescription/application
Chain oil fill
Read and understand
Operator's Manual.
Wear eyes, ears and head
protection
Chain oil pump
Chainbrakeoperation
Emergency stop
Chainoileradjustment
Carburetoradjustment
- Low speed mixture
STOP
Choke control “Cold Start”
position (choke closed)
Carburetoradjustment
- High speed mixture
Gasoline and oil mixture
Carburetoradjustment
- Idle speed
4
TECHNICAL DATA
CS-330T
CS-360T
Model
mm
inch
kg
277 x 247 x 214
10.9 x 9.7 x 8.4
3.6 (7.9 lb)
Dimension
L x W x H
Power head, dry
Weight
Without chain and guide bar
Type
Air-cooled, two-stroke, single cylinder
Displacement
32.6 (1.989 cu.in.)
36.3 (2.215 cu.in.)
Carburetor
Ignition
Spark Plug
Starter
Diaphragm type
Flywheel magneto : CDI system
NGK BPM-8Y - .065 mm (.026 in.) Gap
Recoil starter
Engine
Power transmission
Automatic centrifugal clutch
Mixture ratio
50:1 ratio with Echo Power Blend TM 2-stroke oil.
89 octane unleaded. Do not use fuel containing methyl alcohol,
more than 10% ethyl alcohol or 15% MTBE.
Fuel
Oil
Tank Capacity
Bar and chain
Tank Capacity
Lubrication
ml
ml
310 (10.5 U.S. fl oz.)
ECHO bar and chain oil (or motor oil)
290 (9.8 U.S. fl oz.)
Adjustable automatic oil pump
Guide bar
Saw chain
Standard
14 in.
16 in.
Optional
12, 16 in.
12, 14 in.
Top Handle
Front hand guard
Anti-vibration device
Throttle control lockout
Chain catcher
Standard
features
Spark arrestor catalytic muffler
Idle
Wide Open Throttle (WOT)
2,400 - 2,800
Engine RPM
13,500 - 14,500
Double Guard Low Kick Guide Bar
Low Kick Guard Link Saw Chain
Front Hand Guard/Chain Brake Lever
Chain Brake
Kickback
Safety
Features
Kick Guard
* Technical data subject to change without notice.
5
EMISSION DATA
EMISSION CONTROL
EPA Phase 2
The emission control system for these engines are
EM/TWC (Engine Modification and Catalyst).
IMPORTANTENGINEINFORMATION
ENGINE FAMILY: 6EXHS.0334KB DISPLACEMENT: 32.6 CC
EMISSION COMPLIANCE PERIOD: 300 HOURS
THIS ENGINE MEETS U.S. EPA PH2 AND 2005 - 2006
CALIFORNIA EMISSION REGULATIONS FOR SOREs.
REFER TO OWNER'S MANUAL FOR MAINTENANCE
SPECIFICATIONS AND ADJUSTMENTS.
An Emission Control Label is located on the
engine. (This is an EXAMPLE ONLY, information on
label varies by engine FAMILY).
PRODUCT EMISSION DURABILITY
The 300 hour emission durability compliance period is the time span selected by the manufacturer certify-
ing the engine emissions output meets applicable California and/or U.S. EPA emissions regulations,
provided that approved maintenance procedures are followed as listed in the Maintenance Section of this
manual.
DESCRIPTION
The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging
restrictions, guide bar and saw chain installation and other assembly may be necessary.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or
missing parts. Use the contents list to check for missing parts.
CONTENTS
1 - PowerHead
1 - GuideBar
1 - Kick Guard
1 - Hex Head Bolt
1 - Hex Nut
1 - SawChain
1 - InstructionManual
1 - SafetyManual
1 - WarrantyRegistrationCard
1 - Limited Warranty Statement
1 - T-Wrench
1 - Echo Power Blend TM 2-stroke oil sample
6
|