Clarion Cassette Player RAX650Dz User Manual

Owner’s manual

Mode d’emploi

Manual de instrucciones

RAX650Dz

AM/FMCASSETTEPLAYER

WITHCD/MDCHANGERCONTROL

•

LECTEURDECASSETTEAM/FMAVEC

COMMANDEDECHANGEURCD/MD

•

RADIODEAM/FMYREPRODUCTORDE

CASETESCONCONTROLDECAMBIADORDE

DISCOSCOMAPCTOS/MINIDISCOS

OPEN

Clarion Co., Ltd.

PE-1650B

280-7248-00

Printed in China / Imprimé en Chine / Inpreso en China

1998/11 (A·C)

Handling Cassette Tapes

6. REMOTE CONTROL

1. FEATURES

Using any of the following types of cassette

tapes can cause malfunctions.

• Avoid using cassettes of 120 minutes or

longer. (Such cassettes have extremely thin

tape, so the tape can become stretched or

cut.)

• Periodically play a cleaning cassette in the

player to clean the head.

■ Rotary Encoder Volume Control with Illuminated Search Key

■ Touch-n-Go Flip Down Detachable Face

Receiver for remote control unit

• Cassette tapes with low recording levels

• Cassette tapes in which the unrecorded sec-

tion between tracks is shorter than 4 seconds

• Cassette tapes with noise or the like recorded

between tracks

■ Capability to Read CD TEXT Data from Clarion Compatible CD Changer

■ Z-Enhancer with 3 Adjustment Modes

OPEN

■ CeNET with Balanced Audio Line Transmission and Dynamic Noise Canceling

• Keep magnet items like magnets, and iron and

steel items like screwdrivers away from both

cassette tapes and the tape head in the player.

• Do not oil the cassette mechanism.

• Do not use any cassette tapes with peeling

labels or deformed cases. Such cassette tapes

can cause breakdowns.

• When not using the player, always take the

cassette out of the mechanism. Exposing a

cassette to direct sunlight, extreme tempera-

tures or high humidity can damage the cas-

sette.

■

^®FM Reception System

• Cassette tapes on which there are long unre-

corded sections in the middle of a track

■ Full Logic Tape Transport with True Function / Auto Reverse with Dual Azimuth Adjust

■ Dolby ^®B Noise Reduction

■ 4-Channel RCA Line Level Output with Fader Control

■ 160W (40W×4) Maximum Power Output

Handling precautions

Operating range: 30° in all directions

• Slack in the tape can cause malfunctions. In

particular for prerecorded cassette tapes and

90-minute tapes, take up any slack in the tape

before inserting it into the cassette player.

Remote control unit

Signal transmitter

2. PRECAUTIONS

This unit uses a precision mechanism. Even in the event that trouble arises, never open the case,

disassemble the unit, or lubricate the rotating parts.

This equipment generates, uses, and can radi-

ate radio frequency energy and, if not installed

Flip Down Panel

CAUTION

and used in accordance with the instructions,

may cause harmful interference to radio com-

munications. However, there is no guarantee

that interference will not occur in a particular

installation.

CHANGES OR MODIFICATIONS NOT EX-

PRESSLY APPROVED BY THE MANUFAC-

TURER FOR COMPLIANCE COULD VOID

THE USER’S AUTHORITYTO OPERATETHE

EQUIPMENT.

The RAX650Dz uses a flip-down structure that makes possible large-size displays.

3. Do not use the FLIP DOWN PANEL as a tray

CAUTION

to place objects on when it is open.

When opening and closing the FLIP DOWN

PANEL, be careful not to catch your fingers.

They could be injured.

4. When closing the FLIP DOWN PANEL, do not

press the OPEN button 1.

If this equipment does cause harmful interfer-

ence to radio or television reception, which can

be determined by turning the equipment off and

on, the user is encouraged to consult the dealer

or an experienced radio/TV technician for help.

INFORMATION FOR USERS:.

5. Strong impacts to the operating or display

section can cause damage or deformation.

CHANGES OR MODIFICATIONS TO THIS

PRODUCT NOT APPROVED BY THE MANU-

FACTURER WILL VOID THE WARRANTY

AND WILL VIOLATE FCC APPROVAL.

1. Always use the RAX650Dz with the FLIP

DOWN PANEL closed.

6. If the FLIP DOWN PANEL does not open fully,

gently open it with your hand.

Inserting the Batteries

2. Do not force operations or use this device

abnormally when opening or closing the FLIP

DOWN PANEL.

1. Turn the remote control unit over, then slide

the rear cover in the direction of the arrow.

AA (UM-3/1.5V)

Batteries

2. Insert the AA (UM-3/1.5V) batteries that

came with the remote control unit facing in

the directions shown in the figure, then close

the rear cover.

Notes:

Using batteries improperly can cause them to ex-

plode. Take note of the following points:

•When replacing batteries, replace both batteries

with new ones.

Rear cover

Rear side

•Do not short-circuit, disassemble or heat batteries.

•Do not dispose of batteries into fire or water.

•Dispose of spent batteries properly.

Be sure to unfold and read the next page.

Veuillez déplier et vous référer à la page suivante.

Cerciórese de desplegar y de leer la página siguiente.

RAX6 5 0 Dz

3. CONTROLS / LES COMMANDES / CONTROLES

4. NOMENCLATURE

5. DCP

Note:

The control panel can be detached to prevent theft. When detaching the control panel, store it in the

DCP (DETACHABLE CONTROL PANEL) case to prevent scratches.

• Be sure to read this chapter referring to the front diagrams of chapter “3. CONTROLS” on page 5 (unfold).

Source unit / Appareil pilote / Unidad fuente

We recommend taking the DCP with you when leaving the car.

Names of Buttons

Removing the DCP

1. Hold down POWER button 3 for 1 second or

Attaching the DCP

1. Insert the right side of the DCP into the source

unit.

1 OPEN button

8 Z-EHCR (z-enhancer) button

9 Preset buttons (1 to 6)

Direct buttons (1 to 6) (7 to 12)

0 DISP (display) button

! ISR (instant station recall) button

@ BND (band) button

2 ENT (enter) button

Play/pause button

longer to turn off the power.

OPEN

2. Insert the left side of the DCP into the source

unit.

3 POWER button

FNC (function) button

4 TITLE button

ADJ (adjust) button

PROG (program) button

# A-M (audio mode) button

LD (loudness) button

5 SCN (scan) button

PS/AS (preset scan/auto store) button

6 RPT (repeat) button

BLS (blank skip) button

7 DOLBY NR button

RDM (random) button

2. Deeply push in OPEN button 1 to unlock the

FLIP DOWN PANEL.

$ SEARCH button

With the FLIP DOWN PANEL opened / Ouverture du PANNEAU RABATTABLE /

Apertura del PANEL ABATIBLE

If the FLIP DOWN PANEL does not open fully,

gently open it with your hand.

% Rotary knob

¥ Cassette tape insertion slot

& Eject button

CAUTION

• The DCP can easily be damaged by shocks.

After removing it, be careful not to drop it

or subject it to strong shocks.

Display Items

• If the FLIP DOWN PANEL is kept open, the

DCP may drop due to vibration of the car.

1 Cassette tape in indication

2 Dolby B NR indication

! Long title indication

This results in damage to the DCP. So close

the FLIP DOWN PANEL or remove the DCP

to store into the case.

@ Operation status indication

3. Pull the DCP toward you and remove it.

The frequency, play time, clock, etc. are dis-

played.

3 LD (loudness) indication

4 A-M (audio mode) indication

5 Function mode indication

DCP

• The connector connecting the source unit

and the DCP is an extremely important part.

Be careful not to damage it by pressing on

it with fingernails, screwdrivers, etc.

# RDM (random) indication

$ RPT (repeat) indication

% SCN (scan) indication

¥ BLS (blank skip) indication

& BAND indication

The names of modes being selected, etc. are

displayed.

Display / Afficheur / Visualizador

Note:

6 MANU (manual) indication

7 ST (stereo) indication

• If the DCP is dirty, wipe off the dirt with a soft, dry

cloth only.

8 Z-EHCR (z-enhancer) indication

9 DISC indication

* CD/MD changer mode indication

( TRACK indication

4. Close the HOLD FLAP.

0 Preset channel indication (1 to 6)

Disc number indication (1 to 12)

The disc numbers corresponding to the discs

in the CD or MD changer light.

HOLD FLAP

Note: Be sure to unfold this page and refer to the front diagrams as you read each chapter.

Remarque: Veuillez déplier cette page et vous référer aux schémas quand vous lisez chaque chapitre.

Nota: Cuando lea los capítulos, despliegue esta página y consulte los diagramas.

CAUTION

Be sure to close the HOLD FLAP for safety

when removing the DCP.

RAX6 5 0 Dz